
Straight answer · 3 min read
Do Stumps Have to Come Out Before a Building Pad?
Yes, under the slab, the footings and the driveway. Sawnee Land Clearing pulls those stumps with an excavator around Cumming, Georgia, then backfills and compacts the holes, because roots left to rot leave soft spots that settle later. Stumps outside the pad can stay in the ground, ground below grade for about $100 to $400 each.
Every stump sits on a root system spread through the clay. Leave it under concrete and the roots break down over the years, leaving voids. The fill above them sinks, and so does whatever sits on it. That is why the stump question on a house lot has two answers depending on where the stump sits.
Where on the lot decides what happens
| Where the stump sits | What we do | Why |
|---|---|---|
| Under the slab or footings | Pulled, hole backfilled and compacted | Rotting roots settle under concrete |
| Under the driveway | Pulled before the gravel goes down | Soft spots under gravel sink under trucks |
| Yard and lawn | Ground below grade | A mower and a seeder can cross the spot |
| Pasture or food plot | Ground below grade | A tractor and bush hog can pass over them |
| Woods you’re keeping | Ground flush by the mulcher | Nothing gets built or mowed there |
Grinding costs far less than pulling, so the pad, the driveway and a few feet around them are the only places we pull.
How the stumps come out
- 1Mark each stumpPad corners staked and every stump marked to pull or to grind.
- 2Locate buried linesGeorgia 811 marks utilities at least three business days before digging.
- 3Pull and backfillExcavator lifts the stump and root ball, then the hole is filled and compacted.
- 4Grade the padHigh side cut, low side filled, pad checked against the plan.
On a permitted site the silt fence goes in on the downhill edge before any of this, so loose clay from the stump holes stays on your lot. Wet clay pushes stump work and grading back, and we say so the day we see it.

Ground flush, below grade, or pulled
These are three different jobs, and a quote should say which one each part of your lot gets.
- Flush. A forestry mulcher grinds the stump level with the ground as it clears. Roots stay. Fine in the woods.
- Below grade. A stump grinder takes it under the surface and the grindings fill the hole. Roots stay and rot slowly. Fine under grass.
- Pulled. An excavator lifts the stump and the root ball. The hole gets backfilled and compacted. The only answer under a slab.
Pine stumps stay dead once cut. Sweetgum, oak and maple can sprout from the stump, and so can privet. Around a new house that means a few sprouts in the yard the first season, and a mowing pass handles them. See which trees resprout and maintenance mowing.
What stump work costs
- $100 to $400
- Stump grinding, per stump
- $400 to $800
- Stump grinding, per acre
- $1,200 to $3,500
- Grading, per acre
- $1,800 to $3,000
- Machine day rate with an operator
Ranges are estimates for Forsyth County and the surrounding area based on job density, terrain, access and acreage. Your written quote is the only price that applies to your property.
Pulling shows on the quote as excavator time, because a pine stump and a wide hardwood stump take very different amounts of digging. Rock under the clay and old buried brush piles slow the excavator too. We count and mark the stumps on the walk so the number reflects your lot.
Stumps from an earlier job
Some lots around Cumming were logged or mulched years before anyone planned a house. A logger’s cut-over leaves pine and hardwood stumps at saw height, and an old mulching job leaves them flush and hidden under leaves. Neither counts as stumps out. Once the pad is staked, we find and pull every stump inside it, cut-over or not, and grind the rest below grade where the yard will go.
Who sets the pad spec
Your builder and the house plans decide where the pad goes, how big it is and what elevation it sits at. We cut to that plan and walk the finished pad with you or the builder before the next trade arrives. No builder yet? We can clear the lot now and pull the stumps under the pad once the plan is set.
The full sequence for a house lot, from silt fence to driveway, is on clearing land to build a house, and the finishing work has its own page: stump grinding, grading and pad prep. All of it is part of our land clearing work, on one contract.
FAQ
More about stumps and building pads
- Can I grind the stumps deep instead of pulling them?
- Not under a slab or a footing. Grinding takes the stump below the surface but leaves the root mass in the clay to rot. That works under a lawn and causes trouble under concrete.
- How far past the pad do stumps come out?
- Far enough that the builder's footing trenches and the driveway base don't hit roots. Your builder's plan sets the line, and we mark it on the ground before pulling anything. Past that line, stumps get ground below grade.
- Does forestry mulching remove stumps?
- No. A mulcher grinds stumps flush with the ground and the roots stay. That suits woods, pasture and trails. Under a pad, those flush stumps still come out. More in does forestry mulching remove stumps.
- What happens to the stumps you pull?
- They get ground on site, or hauled away if you ask, which adds to the price. The quote says which, line by line.
